Introduction

This installation manual will help to setup a Yeastar PBX configuration with a MachCloud provided SIP trunk.

This manual assumes that the following is available.

• An operational Yeastar Phone System with admin rights.
• A MachCloud SIP Trunk that has at least one phone number assigned to it.

Installation steps

Follow the steps to add a MachCloud Trunk to the Yeastar PBX.

1. Login into the Yeastar Management Console with administrator privileges via a web browser and select in the menu: Extension and Trunk > Trunk > Add

       

2. Select from dropdown ITSP menu: MachCloud. This will fill-in all relevant Yeastar settings to be able to use MachCloud SIP Trunk.
     
    
    
3. Enter a name for this MachCloud Trunk and check if it is set to ‘Enabled’
   
    
    

4. In the details section: fill-in following information
   Transport: UPD
   Hostname/IP: voice.machcloud.com
   Port: 5060
   Domain: voice.machcloud.com
   Username: <the name of your MachCloud Trunk>
   Password: <password of your MachCloud Trunk>
   
   And click “Save” to confirm 
    
   
   

5. You may check in tab “Advanced” the following settings
   Voip Settings
   
   - DTFM mode: Inband
   - T.38 Support
   
   
   

6. In tab “DIDs/DDIs” you can add/check Phone Numbers which are present at the Trunk
   
   
   

7.  In tab “Inbound Caller Reformatting” no entry needed 
   
   
   

8. In tab “Outbound Caller ID” no entry needed 
    

9. In tab “ SIP Headers” you can check following settings:
   
   - Get Caller ID From: Follow System
   - Get DID Fron: Follow System
   - 100ref: Disabled  
   

 That’s it. Hope you enjoy using the MachCloud Trunks.

(Source: Yeastar_MachCloud_Trunk_settings_EN_v1.1.docx, 2024-07-17)